Browse the glossary using this index

Special | A | B | C | D | E | F | G | H | I | J | K | L | M | N | O | P | Q | R | S | T | U | V | W | X | Y | Z | ALL

Page: (Previous)   1  ...  41  42  43  44  45  46  47  48  49  50  ...  52  (Next)
  ALL

S

Stud bay

A stud bay is the open space that exists between two studs within a wall frame



Substrate

A substrate is a base surface material or layer that is being worked


Sweat

To sweat is the process of sealing and connecting copper and brass fittings with flux, solder, and heat from a torch



Sweep

A sweep is a pipe bend fitting used in drains to permit smooth passage of wastewater and waste.



Swirl marks

Swirl marks are a sanding defect identified by regular circular or arced lines in a sanded surface produced from a spinning circular disk


Symbol

A symbol is a simpler mark, character, or drawing used as a substitute to represent a more complex actual object.



T

Table

The table is ahorizontal saw surface that supports the material while being cut


Table locking knob

Table locking knob is a feature that can be used to lock a miter saw table at any angle



Table saw

A table saw is a saw with a motor and spinning blade mounted in a precision table with a fence guide and blade height and angle adjustments



Tank

The tank of a compressor is a steel walled storage container for holding the pressurized air




Page: (Previous)   1  ...  41  42  43  44  45  46  47  48  49  50  ...  52  (Next)
  ALL